Ac Power Cord Specifications For Mx204 Routers - Juniper MX204 Hardware Manual

SEE ALSO
Replacing an MX204 AC Power Supply | 128
Power Consumption for an AC-Powered MX204 Router | 70
General Safety Guidelines and Warnings | 147
General Electrical Safety Guidelines and Warnings | 172
Prevention of Electrostatic Discharge Damage | 173

AC Power Cord Specifications for MX204 Routers

A detachable AC power cord is supplied with the AC power supply modules. The coupler is type C13 as
described by International Electrotechnical Commission (IEC) standard 60320. The plug at the male end
of the power cord fits into the power source outlet that is standard for your geographical location.
CAUTION:
with that power supply only and not for any other use.
NOTE: In North America, AC power cords must not exceed 4.5 meters (approximately 14.75 feet)
in length, to comply with National Electrical Code (NEC) Sections 400-8 (NFPA 75, 5-2.2) and
210-52 and Canadian Electrical Code (CEC) Section 4-010(3). The cords supplied with the switch
are in compliance.
Table 13 on page 40 gives the AC power cord specifications for the countries and regions listed in the
table.
Table 13: AC Power Cord Specifications
Country/Region
Argentina
Australia
Brazil
The AC power cord provided with each power supply is intended for use
Electrical Specifications
250 VAC, 10 A, 50 Hz
250 VAC, 10 A, 50 Hz
250 VAC, 10 A, 50 Hz
Plug Standards
IRAM 2073 Type RA/3
AS/NZZS 3112 Type
SAA/3
NBR 14136 Type BR/3
Juniper Model Number
CBL-EX-PWR-C13-AR
CBL-EX-PWR-C13-AU
CBL-EX-PWR-C13-BR
40