Table of Contents
Advertisement
12. Once the handrail assembly is located squarely, lock the handrail in position by winding in the
grub screws on the underside of each handrail bracket.
13. Once the handrails are locked in position, fit the handrail endcaps. The endcaps should be
carefully pushed into place until they sit flush with the outside face of each bracket (a light
smear of lubricant such as, washing up liquid on the end cap 'O' rings may ease fitment.
14. Finally, fit the plinth facia to the magnets on the front of the plinth, making sure that on 5
oven appliances the right hand side of the module plinth facia sits against the left hand side of
the AGA Dual Control plinth facia leaving no gap between. Make sure that the plinth facias are
centrally located and do not overhang either appliance. (See Fig. 20)
15. Commission the AGA Dual Control, as stated in the relevant Installation Instructions and carry
out functional test on each of the features of the AGA Dual Control.
20
Advertisement
Table of Contents
