Installation Requirements; Delivery Requirements - AGA Dual Control Series Installation Manual

Glass Yarn, Mineral Wool, Insulation Pads, Ceramic Fibre
May be harmful if inhaled. May be irritating to skin, eyes,
nose and throat. When handling avoid contact with skin or
eyes. Use disposable gloves, face-masks and eye protection.
After handling wash hands and other exposed parts. When
disposing of the product, reduce dust with water spray,
ensure that parts are securely wrapped.
General
• In the event of a fire, cover the pan with a lid and switch
OFF the electricity.
• Smother the flames on the hob rather than attempting
to remove the pan to the outside.
• Burns and injuries are caused almost invariably by
picking up the burning pan to carry outside.
Deep Fat Frying
• Use a deep pan, large enough to completely cover the
appropriate heating area.

Installation requirements

THIS APPLIANCE MUST ONLY BE INSTALLED BY
COMPETENT ENGINEERS WHO HAVE BEEN SPECIFICALLY
FACTORY TRAINED ON THE PRODUCT AND WHO HAVE
THE APPROPRIATE EQUIPMENT.
With specific exceptions, the installing of any type of AGA
cooker is subject to the respective directions contained in
the current issue of the Building Regulations. In addition,
planning permission may need to be obtained, which should
be applied for separately.
The installation of the appliance must be in accordance with
the relevant requirements of the IEE Wiring Regulations and
Building Regulations. It should be in accordance also with
any requirements of the local authority.
In your own interest, and that of safety to comply with the
law. all appliances should be installed by an authorised AGA
engineer or distributor, in accordance with the relevant
regulations.

Delivery requirements

• The AGA DC3 arrives on 1 pallet
• The AGA DC5 (Hotcupboard) arrives on 2 pallets.
There must be access to the kitchen to manipulate a foot
print of 1005mm x 740mm. A wooden template (skate with
castor wheels) of dimensions 1005mm x 740mm could be
used to check if the AGA Total Control fully built appliance is
able to fit through the property grounds and doors into its
installation position in the kitchen. It must also be considered
that the height of the appliance is 960mm off pallet and
1100mm on the pallet, so high level obstacles/restrictions
must not be overlooked.
If this skate/template can be manipulated through the
property grounds and doors into position, then the AGA
Total Control can be installed as intended with no re-work.
3