Table of Contents
Advertisement
Across the expansion card an elastic hold-down is mounted. It must also be removed. Therefore
carefully loosen the screw [4] on each side of the O
If you have removed the top cover and elastic hold-down of the Argus OmniBus in
order to add boards, be sure to replace both parts before powering up again!
Inside of the housing there is a transportation lock, which must also be removed to be able to insert
expansion cards. Loosen the screws
Before closing the housing the transportation lock must be readjusted. Therefore first insert the
plate, then turn in the screws but do not tighten them. Push the plate as far towards the cards as
possible. Just then tighten the screws.
DOC-3266-2
Argus Workstation for Windows
,
and
5
6
7
5
December-2003
B
.
MNI
US
4
Position of screws on the side of A
and take out the plate.
6
Transportation lock of the O
Figure 6-7
O
B
RGUS
MNI
US
7
Figure 6-8
B
MNI
US
6-5
Advertisement
Table of Contents
