Table of Contents
Advertisement
Instrument Operating System
Disk Drive Recovery Process
Disk Drive Recovery Process
The Instrument Recovery System can be used to repair errors on the
instrument's C: drive partition or to restore the original factory configuration of
the system software on the disk drive. The Instrument Recovery System is
stored in a separate hidden disk drive partition.
Restoring the original factory system software does not restore any of the
following items:
— Additional software that has been installed after the instrument was
— System configurations (for example user accounts, windows configurations)
— The Instrument Recovery overwrites the contents of the C: partition. It does
It is recommended that the user use a regular back up strategy. Your IT
department may already have a backup strategy in place that is suitable for the
instrument and its data. Using the Instrument Recovery System in conjunction
with a regular back up strategy should allow you to fully recover the
instrument's software and data.
Table 2-1
Step
1. Make sure the instrument is turned
2. Turn on the instrument.
—Press the down arrow key to move the
M9384B VXG Microwave Signal Generator Startup Guide
shipped from the factory. (Thus, following an Instrument Recovery any
software installed after the instrument was shipped from the factory will
need to be re-installed.)
that have been made after the instrument was shipped from the factory.
(Thus, following an Instrument Recovery configuration changes will have to
be performed.)
not affect the D: or E: partitions.
Recovery Process
off.
highlight to Instrument Recovery
Enter
System, then press
Notes
After the Keysight Technologies screen is
displayed,
This screen is displayed for five seconds.
.
31
Advertisement
Table of Contents
