Panasonic AW-RP501 Service Manual page 18

%4 Pan Reverse Switch [PAN REVERSE, NOR/REV]
Changes the pan direction controlled by PAN/TILT
Lever #8 .
The pan/tilt head turns leftward when
PAN/TILT Lever #8 is moved toward LEFT, or rightward
if it moved toward RIGHT. The rotary head turns in the
opposite direction if the PAN REVERSE Switch %4 is in
the REV position, provided that PAN REVERSE Switch
%4 is in the NOR position.
Switch %4 is set to the REV position, the pan/tilt head
turns in the opposite directions.
With PAN REVERSE Switch %4 in the REV position, the
operating directions shown on the panel are opposite to
the indications on the panel. In this case, paste the sup-
plied seal on the panel.
Note: TILT REVERSE Switch %3 and PAN REVERSE
Switch %4 may be used to reverse the operating
direction of the pan/tilt head, but be sure to set the
operating direction of the pan/tilt head with its
mounting direction selection switch during its instal-
lation depending on whether the pan/tilt head is
mounted on the floor or is suspended.
Unless the mounting direction selection switch on
the pan/tilt head is properly set, the pan/tilt head will
pan or tilt in the opposite direction and the pan/tilt
head operation limiters will not be properly stored in
the memory. For details on the setting of this
switch, refer to INSTALLATION OF PAN/TILT
HEAD.
$9 Speed Switch Changing Switch
[SPEED SW CHANGE, LOW/HIGH]
Changes the polarity of SPEED Switch @9 . If ZOOM
lever #6 , FOCUS Lever #7 , or PAN/TILT Lever #8 is
moved while keeping SPEED Switch @9 depressed, the
corresponding operation takes place at low speed, pro-
vided that SPEED SW CHANGE Switch $9 is in the
LOW position. If one of these levers is moved with
SPEED Switch @9 depressed when SPEED SW
CHANGE Switch $9 is in the HIGH position, the corre-
sponding operation takes place at high speed.
The speed polarity can also be changed by pressing
MEMORY Switch @7 while keeping SPEED Switch @9
depressed. When this step is taken again, the original
speed polarity is restored. Take this step if it is difficult
to shift SPEED SW CHANGE Switch $9 because this
control panel is mounted on a console or the like.
When PAN REVERSE
%0 Zoom Reverse Switch
[ZOOM REVERSE, NORM/REV]
Changes the operating direction of ZOOM Lever #6 .
The lens zoom moves toward TELE when ZOOM Lever
#6 is moved toward TELE, or toward WIDE when it is
moved toward WIDE, provided that ZOOM REVERSE
Switch %0 is in the NOR position.
REVERSE Switch %0 is set to the REV position, lens
zoom operation takes place in the opposite direction.
With ZOOM REVERSE Switch %0 in the REV position,
the operating directions shown on the panel are
reversed. In this case, paste the supplied seal on the
panel.
%1 Zoom/Focus Exchange Switch
[ZOOM/FOCUS EXCHANGE, ON/OFF]
ZOOM Lever #6 and FOCUS Lever #7 exchange their
function between them when this switch is set to the ON
position. Unless this exchange is needed, keep the
switch in the OFF position.
With ZOOM/FOCUS EXCHANGE Switch %1 in the ON
position, the operations shown on the panel do not
agree with the indications on the panel. In this case,
paste the supplied seal on the panel.
15
When ZOOM