Panasonic AW-RP501 Service Manual page 16

The pan/tilt head moves in the opposite direction if the
TILT REVERSE Switch %3 is in the REV position. The
pan/tilt head turns leftward when the lever is moved
toward LEFT, or rightward when it is moved toward
RIGHT, provided that PAN REVERSE Switch %4 is in
the NOR position. The pan/tilt head moves in the oppo-
site direction if the PAN REVERSE Switch %4 is in the
REV position.
REAR PANEL
#9 TALLY Terminal [TALLY] (6-pin Terminal Board)
Connect it to the tally connector on a special effect gen-
erator (SEG) or a video switcher, for example. When the
voltage of any of the jacks [1] to [5] of the terminal falls
to the ground level, the corresponding TALLY Indicator
@1 and the Tally Indicator on the Pan/tilt Head (AW-
PH300) light red.
$0 12V DC Input Connector [DC 12V IN] (DC Jack)
Connect the AC Adapter AW-PS301 (optional).
$1 1 Cord Clamp
Clamps the DC cord of the AC Adapter AW-PS301
(optional) connected to DC 12V IN Connector $0 to pre-
vent its disconnection.
8-pin DIN connector
pin assignment
(as viewed from the
rear of the control panel)
Example of auxillary
control circuit
G / L I N PREVIEW MONITOR OUT
T D M U L T I P O R T H U B
P A N / T I L T C A M E R A
CONTROL OUT CONTROL OUT G/L OUT PREVIEW IN
Ground
6
7
8
3
1
5
4
Zoom
2
control
1 +5V
10KΩ
100Ω
2 ZOOM
100Ω
3 FOCUS
100Ω
4 TILT
100Ω
5 PAN
6 GND
SPEED switch
7 SPEED
8 IRIS
Note: Make sure that the lens and pan/tilt head stop
Ground GND
at the center point of the zoom, focus, pan and tilt controls
(or at the lever reset position if the controls have a lever reset function).
Note: TILT REVERSE Switch %3 and PAN REVERSE
Switch %4 may be used to reverse the operating
direction of the pan/tilt head, but be sure to set the
operating direction of the pan/tilt head with its
mounting direction selection switch during its instal-
lation depending on whether the pan/tilt head is
mounted on the floor or is suspended. Unless the
mounting direction selection switch on the pan/tilt
head is properly set, the pan/tilt head will pan or tilt
in the opposite direction and the pan/tilt head opera-
tion limiters will not be properly stored in the memo-
ry. For details on the setting of this switch, refer to
INSTALLATION OF PAN/TILT HEAD.
D C 1 2 V I N
AUX CONTROL IN
T A L L Y
5 4 3 2
$2 Auxiliary Control Input Connector
[AUX CONTROL IN] (8-pin DIN Connector)
External control signals are input to this connector in
controlling the head's pan/tilt, lens zoom, focus and iris
operations.
Note: In externally controlling the pan/tilt head and lens
through this connector, set IRIS LEVEL Control @6
on this control panel to the centre point (straight
up), and do not simultaneously operate SPEED
Switch @9 , ZOOM Lever #6 , FOCUS Lever #7 , and
PAN/TILT Lever #8 . Operation errors may occur if
external controls are simultaneously used.
Focus Tilt Pan
control control control
10KΩ
10KΩ
10KΩ
13
1
6.8KΩ
Iris control
20KΩ
6.8KΩ