Table of Contents
Advertisement
11. Add Genius I/O devices to the Genius Bus by right-clicking geniusgateway... and selecting
Change Module List.... (see Figure 17). If the application is a retrofit of an existing Genius
solution, be sure to set all I/O reference addresses to match those of the Genius configuration
being incorporated. To ease confusion, it is also recommended that the Genius Devices be
assigned the same serial bus addresses (Location column) as had been assigned in the system
under retrofit.
12. Select individual Genius I/O devices from the right-hand panel of Figure 17 and then drag/drop
them into the appropriate location row on the left-hand side, resulting in Figure 18.
GFK-2892F
Figure 17: Change Module List for Genius Gateway GCG001
March 2019
Chapter 3. Configuration
29
Advertisement
Table of Contents
