Figure 14: Hardware Configuration Expanded Tree; Figure 15 - Gcg Data Reference Addresses; Figure 16: Genius Gateway Parameters - GE GFK-2892F User Manual

Pacsystems rx3i genius communications gateway

Hide thumbs

Table Of Contents

Table of Contents

Chapter 3. Configuration

geniusgateway...

now appears

(Figure 14) as an IO

device in the

Hardware

Configuration tree

under the PNC001.

Within the

geniusgateway

branch, two daughter devices

are displayed by default: the

GCG (shown in Figure 16 at slot 0 with its connected PNC) and the Gateway module itself at slot

31. You may drag the gateway to slot 30, if desired.

Note that slot 0, normally used by the Genius HHM, is not really consumed by the GCG001. The

slot 0 indication for the GCG001 in the PME display should be ignored: no I/O module may be

dragged into the slot.

Note:

geniusgateway... is the default PROFINET Device Name that PME gives to a GCG001 in

the Hardware Configuration under a PNC001. This Device Name must match that given

to the module itself using the PROFINET/DCP (Discovery and Configuration Protocol) tool

(Figure 12). If there are multiple GCG001s on a PROFINET bus, each of the modules'

Device Names must be unique. You can change it by selecting the device in the

Navigator, then typing in a new name in the Inspector.

Example: GCG_inside and GCG_outside are acceptable Device Names.

Enter the reference addresses for Genius Status Data, Fault Status Data, and Gateway Status

10. If desired, change the GCG001 configuration parameters for Genius Bus Baud Rate and Output at

Startup (Figure 16). Select the GENIUS Gateway Module in slot 31 (or slot 30) and double-click it.

You can now use the pull-down menus to select the appropriate Baud Rate and Output at Startup

value.

When Output at Startup is set to Disabled, no output data is sent to the Genius devices when the

PLC transitions from STOP to RUN. In this case, the Enable/Disable Outputs COMMREQ must be

used to enable outputs on the Genius bus.