Field Installation - Siemens UL 489 Operating Instructions Manual

18.1.1 Field installation

Hazardous voltage.
Will cause death, serious personal injury, or equipment damage.
Turn off and lock out all power supplying this equipment before working on this device.
Install Shutter Mounts
Shutter mounting assemblies are used to support the shutter assembly. There are four shutter mounts per shutter (as noted by the 
arrows below).
2
2
Place each shutter mounting assembly into the cradle locking holes – first by inserting the rear tines (1A) and then rotating the assembly
towards the cradle sidewall (1B). Ensure that the locating dowel pins are seated. The front tines will pass through the rectangular opening in
the cradle sidewall.
1A
DANGER
1B
2
2
18 – 2