Table of Contents
Advertisement
Display installation
Warning:
Fasten the power connector to your display with the screws provided at the sides of the
connector.
2.
Plug the other end of the external DC power supply into a grounded power outlet by means of the proper
power cord delivered in the packaging.
Use the external power supply delivered with your display. If you do not use the correct power
supply, the display will not start up.
3.7 Mounting the film clip
To mount the film clip
The film clip can be mounted on the top side of the display.
1.
Position the film clip on the top side of the bezel at the desired location (in the middle, left or right).
2.
To remove the film clip, lift the front end or rear end of the clip.
3.8 Mounting the MultiTouchPad
To mount the MultiTouchPad
1.
Connect the MultiTouchPad to one of the USB downstream connectors (using either those found in the cable
compartment or on the right side of the display).
20
K5902079-07
Coronis Uniti
Advertisement
Table of Contents
