Table of Contents
Advertisement
2.2 Installation
Installation and preliminary adjustments should be performed by qualified Barco
personnel or authorized Barco service dealers.
Installation of the monitor shall comply with the safety instructions as listed in chapter
•
Make sure that the installation place has sufficient stability!
•
Do not place the monitor near heat sources!
•
Use maximum 15mm/0.59 inch long screws. Longer screws may damage the monitor!
•
Ensure that the display is operating within the specified operating range +5°C – +40°C | 41°F – 104°F, at max.
90% RH, non-condensing.
•
Never restrict airflow into the display by blocking any vents or air intakes.
•
Leave a clearance on all vented sides of the display to permit the required airflow. Clearance should me
minimum 15 cm but may be larger depending on the ambient environment.
Do not install the unit where it may be easily touched or leaned against. Avoid locations
subject to high vibrations or severe impacts. Do not install the unit where it is exposed to
humidity, oil, smoke or excessive dust.
2.2.1 Mounting of the table stand (optional)
The table stand is an optional component.
To mount the table stand, proceed as follows:
•
Lay the monitor upside down on a clean(!) surface.
Soil or particles laying on the surface may irretrievably damage the screen of the monitor!
•
Unpack the table stand
In the package of the table stand the required screws are included.
•
Use the screws to mount the table stand.
•
When the screws are fastened tightly, put up the monitor.
Barco - LC series - R5976934 - user's manual - Revision 05 - March 2006
_____________________________________________________________________________________
2. Unpacking and installation
1.3.1 Safety on installation
2-3
Advertisement
Table of Contents
