Table of Contents
Advertisement
Preparing for Installation
This chapter describes the general equipment, safety, and site preparation requirements for installing the
PA-4T+. This chapter contains the following sections:
•
•
•
•
•
Required Tools and Equipment
You need the following tools and parts to install a PA-4T+. If you need additional equipment, contact a
service representative for ordering information.
•
•
•
•
•
•
•
•
•
•
•
OL-3561-04
Required Tools and Equipment, page 2-1
Software and Hardware Requirements, page 2-2
Checking Hardware and Software Compatibility, page 2-3
Safety Guidelines, page 2-3
FCC Class A Compliance, page 2-10
PA-4T+
Catalyst RSM/VIP2 (for installation in the Catalyst 5000 family switches). For information about
the specific VIP2 models that support the PA-4T+, see the
section on page
2-2.
Catalyst 6000 family FlexWAN module (for installation in the Catalyst 6000 family switches)
VIP (for installation in Cisco 7000 series or Cisco 7500 series chassis only)
Cisco 7304 PCI Port Adapter Carrier Card (for installation in a Cisco 7304 router)
Serial cables appropriate for the desired port adapter interface types and the desired modes. (See the
"Cables, Connectors, and Pinouts" section on page
Number 1 Phillips and a 3/16-inch flat-blade screwdriver (for VIP installation only)
Number 2 Phillips screwdriver
Your own electrostatic discharge (ESD)-prevention equipment or the disposable grounding wrist
strap included with all upgrade kits, field-replaceable units (FRUs), and spares
Antistatic mat
Antistatic container
C H A P T E R
1-5.)
PA-4T+ Synchronous Serial Port Adapter Installation and Configuration
2
"Software and Hardware Requirements"
2-1
Advertisement
Table of Contents
