Table of Contents
Advertisement
Configuring the Interfaces
Table 5-3
Examples of the interface serial Subcommand for the Supported Platforms (continued)
Platform
Cisco 7301 router
Cisco 7304 PCI Port Adapter Carrier
Card in a Cisco 7304 router
Cisco 7401ASR router
VIP in Cisco 7000 series or Cisco 7500
series routers
Assign an IP address and subnet mask to the interface (if IP routing is enabled on the system) by using
Step 3
the ip address configuration subcommand, as in the following example:
Router(config-if)# ip address 10.10.10.10 255.255.255.255
Add any additional configuration subcommands required to enable routing protocols and set the
Step 4
interface characteristics.
Note
Set the clock rate with the clock rate command. (See the
Step 5
on page
Router(config-if)# clock rate 64000
Re-enable the interfaces using the no shutdown command. (See the
Step 6
section on page
Configure all additional port adapter interfaces as required.
Step 7
When you have included all of the configuration subcommands to complete the configuration, press
Step 8
Ctrl-Z (hold down the Control key while you press Z) or enter end to exit configuration mode and
return to the EXEC command interpreter prompt.
PA-4T+ Synchronous Serial Port Adapter Installation and Configuration
5-10
Command
interface serial, followed by
slot/port
(port-adapter-slot-number/
interface-port-number)
interface serial, followed by
slot/port (module-slot-number/
interface-port-number)
interface serial, followed by
slot/port
(port-adapter-slot-number/
interface-port-number)
interface serial, followed by
slot/port adapter/port
(interface-processor-slot-number/
port-adapter-slot-number/
interface-port-number)
If you are configuring a DTE interface, proceed to Step 6. If you are configuring a DCE
interface, you need to configure the external clock signal, as described in the next step.
The example in Step 5 applies to all systems in which the PA-4T+ is supported.
5-11.)
5-2.)
Chapter 5
Configuring the PA-4T+ Interfaces
Example
The example is for interface 0 of a
port adapter in port adapter slot 1.
Router(config)# interface serial 1/0
Router(config-if)#
The example is for interface 0 on a port
adapter in a Cisco 7304 PCI Port Adapter
Carrier Card in module slot 3 of a Cisco 7304
router.
Router(config)# interface serial 3/0
Router(config-if)#
The example is for interface 0 of a
port adapter in port adapter slot 1.
Router(config)# interface serial 1/0
Router(config-if)#
The example is for interface 0 of a
port adapter in port adapter slot 1 of a VIP in
interface processor slot 1.
Router(config)# interface serial 1/1/0
Router(config-if)#
"Configuring Timing (Clock) Signals" section
"Shutting Down an Interface"
OL-3561-04
Advertisement
Table of Contents
