Network Equipment-Building System (Nebs) Statements - Cisco 4112 Hardware Installation Manual

Network Equipment-Building System (NEBS) Statements

Network Equipment-Building System (NEBS) Statements
NEBS describes the environment of a typical United States Regional Bell Operating Company (RBOC) central
office. NEBS is the most common set of safety, spatial, and environmental design standards applied to
telecommunications equipment in the United States. It is not a legal or regulatory requirement, but rather an
industry requirement.
The following NEBS statements apply to the Firepower 4125:
Note
Warning
Note
Cisco Firepower 4112, 4115, 4125, and 4145 Hardware Installation Guide
42
Statement 7001 ESD Mitigation
This equipment may be ESD sensitive. Always use an ESD ankle or wrist strap before handling equipment.
Connect the equipment end of the ESD strap to an unfinished surface of the equipment chassis or to the ESD
jack on the equipment if provided.
Statement 7003—Shielded Cable Shielded Cable Requirements for Intrabuilding Lightning Surge
The intrabuilding port(s) of the equipment or subassembly must use shielded intrabuilding cabling/wiring that
is grounded at both ends.
The following port(s) are considered intrabuilding ports on this equipment:
Gigabit Ethernet management port
RJ-45 1 G/100 M/10 M auto duplex/auto MDI-X Base-T ports
Statement 7004—Special Accessories Required to Comply with GR-1089 Emission and Immunity
Requirements
To comply with the emission and immunity requirements of GR-1089, shielded cables are required for the
following ports:
Gigabit Ethernet management port
RJ-45 1 G/100 M/10 M auto duplex/auto MDI-X Base-T ports
Installation Preparation