Cisco PA-4T+ Installation And Configuration Manual page 72

Determining the Port Mode
For a VIP, use the following commands:
Router> enable
Password:
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)# interface serial 3/1/0
Router(config-if)# shutdown
Ctrl-Z
Router#
For a Catalyst 6000 family FlexWAN module, use the following commands:
Router# configure terminal
Enter configuration commands, one per line.
Router(config)#
Router(config)# interface serial 3/0/0
Router(config-if)# shutdown
Ctrl-Z
Router#
For a Catalyst RSM/VIP2, use the following commands:
Router> enable
Password:
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)# interface serial 1/0
Router(config-if)# shutdown
Ctrl-Z
Router#
Locate and remove the adapter cable to be replaced.
Step 2
Connect the new cable between the PA-4T+ and the network connection. Tighten the thumbscrews at
Step 3
both ends of the cable to secure it in the ports.
Enter configuration mode again, bring the port back up, and save the running configuration to NVRAM.
Step 4
For the Cisco 7100 series routers, Cisco 7200 series routers, Cisco uBR7200 series router,s Cisco 7201
router, Cisco 7301 router, or Cisco 7401ASR router use the following commands:
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)# interface serial 1/0
Router(config-if)# no shutdown
Ctrl-Z
Router#
Router# copy running-config startup-config
For a VIP, use the following commands:
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)# interface serial 3/1/0
Router(config-if)# no shutdown
Ctrl-Z
Router#
Router# copy running-config startup-config
PA-4T+ Synchronous Serial Port Adapter Installation and Configuration
4-4
Chapter 4 Attaching the PA-4T+ Interface Cables
End with CNTL/Z.
OL-3561-04