Table of Contents
Advertisement
Chapter 5
Configuring the PA-4T+ Interfaces
Last reset from power-on
G.703/E1 software, Version 1.0.
SuperLAT software copyright 1990 by Meridian Technology Corp).
Bridging software.
X.25 software, Version 2.0, NET2, BFE and GOSIP compliant.
TN3270 Emulation software (copyright 1994 by TGV Inc).
Chassis Interface.
1 VIP2 controller (4 Ethernet)(4 Serial).
4 Ethernet/IEEE 802.3 interfaces.
4 Network Serial interfaces.
125K bytes of non-volatile configuration memory.
16384K bytes of Flash PCMCIA card at slot 1 (Sector size 128K).
8192K bytes of Flash internal SIMM (Sector size 256K).
Configuration register is 0x0
Using the show diag Command
Display the types of port adapters installed in your system (and specific information about each) using
the show diag slot command, where slot is the port adapter slot in a Catalyst 5000 family switch, a Cisco
7100 series router, Cisco 7200 series router, Cisco 7200 VXR router, Cisco uBR7200 series, Cisco 7201
router, Cisco 7301 router, and Cisco 7401ASR router, the module slot in a Cisco 7304 PCI Port Adapter
Carrier Card in a Cisco 7304 router, and the interface processor slot in a Cisco 7000 series router or
Cisco 7500 series router with a VIP. In the FlexWAN module, the show diag command is used without
the slot designation.
Note
The outputs that appear in this document may not match the output you receive when running these
commands. The outputs in this document are examples only.
Note
The slot argument is not required for Catalyst 5000 family switches.
The following sections provide platform-specific output examples using the show diag command:
•
•
•
•
•
•
OL-3561-04
Catalyst RSM/VIP2 in Catalyst 5000 Family Switches—Example Output of the show diag
Command, page 5-26
Catalyst 6000 Family FlexWAN Module—Example Output of the show diag Command, page 5-26
Cisco 7100 Series Routers, Cisco 7200 Series Routers, Cisco 7200 VXR Routers, and
Cisco uBR7200 Series Routers—Example Output of the show diag Command, page 5-26
Cisco 7201 Router—Example Output of the show diag Command, page 5-27
Cisco 7401ASR Router—Example Output of the show diag Command, page 5-27
VIP in Cisco 7000 Series Routers and Cisco 7500 Series Routers—Example Output of the show diag
Command, page 5-28
PA-4T+ Synchronous Serial Port Adapter Installation and Configuration
Checking the Configuration
5-25
Advertisement
Table of Contents
