Table of Contents
Advertisement
Checking the Configuration
Catalyst 6000 Family FlexWAN Module in Catalyst 6000 Family Switches—Example Output of the show interfaces Command
Following is an example of the show interfaces serial command for a Catalyst 6000 Family FlexWAN
module in a Catalyst 6000 family switch. This example shows all of the information specific to interface
port 0 on a PA-4T+ installed in port adapter slot 8 (interfaces are administratively shut down until you
enable them):
Router# show interfaces serial 8/1/0
Serial8/1/0 is administratively down, line protocol is down
Hardware is Serial
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec,
Encapsulation HDLC, crc 16, loopback not set
Keepalive not set
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
Cisco 7100 Series Routers, Cisco 7200 Series Routers, Cisco 7200 VXR Routers, and Cisco uBR7200 Series Routers—Example
Output of the show interfaces Command
Following are examples of the show interfaces serial command from a Cisco 7100 series routers. In
these examples, the eight serial interfaces (0 to 7) are on a port adapter in port adapter slot 1; also, most
of the status information for each interface is omitted. (Interfaces are administratively shut down until
you enable them.)
Router# show interfaces serial 1/0
Serial1/0 is up, line protocol is up
Hardware is M4T
Internet address is 10.10.10.1
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation PPP, loopback not set, keepalive set (10 sec)
(display text omitted]
Router# show interfaces serial 1/1
Serial1/1 is up, line protocol is up
Hardware is M4T
Internet address is 10.10.10.2
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation PPP, loopback not set, keepalive set (10 sec)
(display text omitted]
Router# show interfaces serial 1/2
Serial1/2 is up, line protocol is up
Hardware is M4T
Internet address is 10.10.10.3
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation PPP, loopback not set, keepalive set (10 sec)
(display text omitted]
PA-4T+ Synchronous Serial Port Adapter Installation and Configuration
5-30
reliability 255/255, txload 1/255, rxload 1/255
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
RTS down, CTS down, DTR down, DCD down, DSR down
Chapter 5
Configuring the PA-4T+ Interfaces
OL-3561-04
Advertisement
Table of Contents
