Preparing To Install The Wism2; Required Tools - Cisco WS-SVC-WISM2-1-K9 Installation And Verification Note

Hazardous voltage or energy is present on the backplane when the system is operating. Use caution
Warning
when servicing. Statement 1034
Blank faceplates and cover panels serve three important functions: they prevent exposure to
Warning
hazardous voltages and currents inside the chassis; they contain electromagnetic interference (EMI)
that might disrupt other equipment; and they direct the flow of cooling air through the chassis. Do not
operate the system unless all cards, faceplates, front covers, and rear covers are in place. Statement
1029
This unit is intended for installation in restricted access areas. A restricted access area can be
Warning
accessed only through the use of a special tool, lock and key, or other means of security.
Statement 1017

Preparing to Install the WiSM2

Before installing the WiSM2, you must install the Catalyst 6500 series switch chassis and at least one
Note
supervisor engine. For information on installing the switch chassis, see the Catalyst 6500 Series Switch
Installation Guide.
Before installing the WiSM2, make sure that the following items are available:
•
•

Required Tools

Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
These tools are required to install the WiSM2 into the Catalyst 6500 series switch:
•
•
•
78-16318-01
Catalyst 6500 series switch chassis
Management station that is available through a console connection to perform configuration tasks
Flat-blade screwdriver
Wrist strap or other grounding device
Antistatic mat or antistatic foam
Catalyst 6500 Series Wireless Services Module 2 Installation and Verification Note
9