Table of Contents
Advertisement
Configuring the PA-4T+ Interfaces
To continue your PA-4T+ port adapter installation, you must configure the serial interfaces. The
instructions that follow apply to all supported platforms. Minor differences between the platforms are
noted.
This chapter contains the following sections:
•
•
•
•
Using the EXEC Command Interpreter
You modify the configuration of your router through the software command interpreter called the EXEC
(also called enable mode). You must enter the privileged level of the EXEC command interpreter with
the enable command before you can use the configure command to configure a new interface or to
change the existing configuration of an interface. The system prompts you for a password if one is set.
The system prompt for the privileged level ends with a pound sign (#) instead of an angle bracket (>).
At the console terminal, use the following procedure to enter the privileged level:
Step 1
At the user-level EXEC prompt, enter the enable command. The EXEC prompts you for a
privileged-level password as follows:
Router> enable
Password:
Enter the password (the password is case-sensitive). For security purposes, the password is not
Step 2
displayed.
When you enter the correct password, the system displays the privileged-level system prompt (#):
Router#
OL-3561-04
Using the EXEC Command Interpreter, page 5-1
Configuring the Interfaces, page 5-2
Configuring Half-Duplex and Binary Synchronous Communications in Cisco 7200 Series Routers,
page 5-16
Checking the Configuration, page 5-18
C H A P T E R
PA-4T+ Synchronous Serial Port Adapter Installation and Configuration
5
5-1
Advertisement
Table of Contents
