Table of Contents
Advertisement
3. Installing the product
3.1 Installing the controller
3.1.1 Location
Install the product in a location that meets the following requirements:
•
•
•
•
•
Related information
• 13.1 Operating conditions
3.1.2 Mechanical installation
3.1.2.1 Installing the controller
You can install the controller without removing the front cover.
1. Mark up the holes on a plane wall.
2. Drill the holes.
3. Remove the plastic caps that cover the screw holes in the controller or open the control cab-
4. Install the controller with the cable entries pointing downwards.
5. Fit the screws.
6. Fit the plastic caps, if any.
3.1.3 Electrical connection
Place the product in a flood-safe place.
Make sure that the ambient temperature is within the limits.
Install the product as close as possible to the lifting station.
If you install the product outdoors, place it in a protective shed or enclosure, class IP55.
Do not expose the product to direct sunlight.
CAUTION
Back injury
Minor or moderate personal injury
● Use lifting equipment.
CAUTION
Crushing of feet
Minor or moderate personal injury
● Wear safety shoes when moving the product.
inet.
If required, fit additional cable entries in the bottom plate of the control cabinet.
DANGER
Electric shock
Death or serious personal injury
● Switch off the power supply before you start any work on the product. Make
sure that the power supply cannot be accidentally switched on.
Multilift MD1, MDV | | 8
Advertisement
Table of Contents
