Product Description; Applications; Pumped Liquids; Lifting Station - Grundfos Multilift MD1 Installation And Operating Instructions Manual

Hide thumbs Also See for Multilift MD1:
Table of Contents

Advertisement

5. Product description

5.1 Applications

The product is designed for the collection and pumping of wastewater with no free flow to sewer
level. Typically the product is installed below sewer level in cellars or basements in buildings such
as:

5.2 Pumped liquids

The product is designed for the collection and pumping of these liquids:
The free passage of the product enables pumping of liquids containing solids from 65 to 80 mm in
diameter, depending on the pump type.
Do not discharge these substances or types of wastewater via the product:
Related information
• 13.1 Operating conditions

5.3 Lifting station

5.3.1 Tank

The gas-, odour- and pressure-tight tank is made of resistant polyethylene. The tank has all nec-
essary ports for the connection of inlet pipes, outlet pipe, vent pipe and a manually operated dia-
phragm pump available as an accessory.
Inside the tank the two pump connections are connected to a suction bend enabling suction from
the bottom. As a result, the residual volume is reduced to a minimum.
The table below shows the tank volume and the effective volume. The effective volume is the vol-
ume between start and stop.
Number of tanks
Tank volume [l]
Effective volume with stop delay [l]
Effective volume without stop delay [l]
large-scale multifamily houses
public and commercial buildings
blocks of flats
schools
offices
hotels
restaurants
hospitals
industries.
wastewater
sludge-containing water
domestic wastewater containing faecal matter.
Solid matter, tar, sand, cement, ash, coarse paper, paper towels, cardboard, debris, gar-
bage, grease and oil.
Wastewater from sanitary installations situated below the backflow level must be drained
away via a free-flow drainage system according to EN 12056-1.
Wastewater containing hazardous substances such as greasy wastewater from large-scale
catering establishments.
For drainage of greasy wastewater, use a grease separator according to EN 1825.
Rainwater of large areas outside the building, for example parking lots, must be collected
and discharged outside the building with separate pumping stations.
Multilift MD1, MDV | | 16
1
2
3
450
900
1350
225
450
675
150
300
450

Advertisement

Table of Contents
loading

This manual is also suitable for:

Multilift mdv

Table of Contents