Wire-Wrap Section, X6; Wire-Wrap Area; 42-Pin Header - Digi ConnectCore 7U Hardware Reference Manual

A B O U T T H E D E V E L O P M E N T B O A R D
2

Wire-wrap section, X6

W i r e - w r a p s e c t i o n , X 6
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
The X6 section on the development board includes a 77-pin wire-wrap area and a 42-
pin header.

Wire-wrap area

The wire-wrap area allows you to connect through-hole components for rapid
prototyping purposes.

42-pin header

You can place an optional 42-pin header (reference part: Samtec TSW-127-07-D) here.
This header connector is a through-hole signal rail that provides 1:1 access to module
signals. The size of the connector is 2x21 pins.
ConnectCore 7U Hardware Reference, Rev A 01/2007
24
Wire-wrap area and
42-pin header, X6