Elcometer 456 IPC User Manual page 6

4 GETTING STARTED (continued)
4.3 SELECTING YOUR LANGUAGE
1 Press and hold the ON/OFF button until the Elcometer logo is
displayed.
2 Press Menu/Setup/Language and select your language using the
  softkeys.
3 Follow the on screen menus.
To access the language menu when in a foreign language:
1 Switch the gauge OFF.
2 Press and hold the left softkey and switch the gauge ON.
3 Select your language using the
4.4 SCREEN SETTINGS
A number of screen settings can be defined by the user via
Menu/Setup/Screen Settings including:
Screen Brightness; This can be set to 'Manual' or 'Auto' - the

brightness is adjusted automatically using the gauge's ambient
light sensor.
Screen Timeout; The display will dim if inactive for more than

15 seconds and will go 'black' if inactive for the period defined.
The gauge can also be set to switch off automatically after 5
minutes of inactivity via Menu/Setup/Gauge Auto Off.
Screen Rotation; Using the internal accelerometer, the gauge

rotates the display to allow the user to measure or read values at
0°, 90°, 180° and 270° orientation if 'Auto Display Rotation' is
selected via Menu/Setup/Auto Display Rotation.
4.5 SELECTING THE MEASUREMENT UNITS
Readings can be displayed in µm or mils. To select the measurement
units, press Menu/Setup/Units.
4.6 SELECTING THE APPROPRIATE CALIBRATION MEMORY
The Elcometer 456 IPC gauge is factory calibrated to ensure accurate
measurement on blast profiled, ferrous (steel) substrates.
The gauge has been pre-calibrated with four profile measurement
ranges (see table on page en-6) which are determined by the
measurement units selected by the user.
en-5
R
 
softkeys.
www.elcometer.com