Assembly; Installing Wheels And Feet; Installing Lift Bracket - Westinghouse WGen12000DF User Manual

ASSEMBLY

INSTALLING WHEELS AND FEET

BEFORE ASSEMBLING THE
GENERATOR, REVIEW THE SAFETY
SECTION STARTING ON PAGE 5.
CAUTION
Never lift the generator without
assistance. The generator is heavy
and lifting without assistance could
result in personal injury.
Never use the handles as a lifting point
to support the entire weight of the
generator. Only use the handles to move
the generator by lifting the handles and
using the wheels to move the generator.
Use caution when collapsing the
handles. Hands and fingers could get
caught and pinched.
NOTICE
Assembling the generator will require lifting the unit
on one side. Make sure all engine oil and fuel are
drained from the unit prior to assembling. Once
assembled, the wheel kit is not intended for on-
road use. The wheel kit is designed for use on this
generator only.
INSTALLING WHEELS TO FRAME
1. Insert axle bolt through washer and wheel and slide
hairpin cotter into top of the axle bolt to prevent it
from sliding off the wheel.
Figure 1 - Install Wheels
2. Install the axle bolt and wheel through another
washer and then through the axle bracket on the
frame.
10 | Westinghouse Outdoor Power Equipment
3. Install the hairpin cotter through the end of the axle
bolt to lock it in place.
4. Repeat previous steps on other wheel.

INSTALLING LIFT BRACKET

1. Align the lifting bar with the mounting brackets on the
top of the fuel tank and secure with the 4 M8 flange
bolts provided.
Figure 2 - Install Lift Bracket