Mitsubishi 6M70 Workshop Manual page 28

ON-VEHICLE INSPECTION AND ADJUSTMENT
Mitsubishi 6M70 Engine Parts contact:
email: EngineParts@HeavyEquipmentRestorationParts.com
Phone: 269 673 1638
11-18
• Screw in or out the adjusting screw on the rocker arm until the
correct feeler gauge can be inserted with a slight resistance.
• After adjustment, while holding the adjusting screw in this posi-
tion with a screwdriver, tighten the lock nuts to the specified
torque.
• Recheck the valve clearance using the correct feeler gauge.
CAUTION
• If the valve clearance has been adjusted, be sure to check
and adjust the Powertard clearance. (See later section.)
• After the adjustment is complete, install the rocker cover and the
gasket. (See "ROCKER COVER, ROCKER AND SHAFT".)