Inspection Of Mprop - Mitsubishi 6M70 Workshop Manual

INSPECTION OF ELECTRICAL EQUIPMENT
13-92

#574 Inspection of MPROP

(rail pressure control valve)
• Measure the resistance between terminals 1 and 2. Identify
MPROP1 and 2 by "M/P-1" and "M/P-2" labeled on the harness.
Standard value
(at 20°C)
• If the measurement is out of specification, replace the supply
pump.
#582 Inspection of Mitsubishi 6M70 injector magnetic valve
• Measure the resistance between terminals 1 and 2.
Standard value (at 20 to 70°C)
• If the measurement is out of specification, replace the injector.
#828 Inspection of fuel injection rate adjustment resistor
• Measure the resistance of the resistor number marked on the
fuel injection rate adjustment resistor.
Standard value
Resistor No.
(at 20°C)
• If the measurement is out of specification, replace the fuel injec-
tion rate adjustment resistor with one that has the same resistor
number and same specified resistance.
CAUTION
• The fuel injection rate adjustment resistor is matched to the
engine. If you replace it, be sure to replace it with one that
has the same resistor number.
2.6 to 3.15 Ω
0.21 to 0.295 Ω
270 ± 13.5 Ω
1
510 ± 25.5 Ω
2
820 ± 41 Ω
3
1300 ± 65 Ω
4
5 2000 ± 100 Ω
3300 ± 165 Ω
6
7 5600 ± 280 Ω
15000 ± 750 Ω
8
9 390 ± 19.5 Ω
4300 ± 215 Ω
10
11 9100 ± 455 Ω