Bay Networks Remote Annex 4000 Hardware Installation Manual page 65

To enable your VAX VMS load host to accept crash dumps:
1 Assign a DECnet node number to your Remote Annex. You can pick
any node number or name as long as it does not conflict with any
node or address already defined within NCP .
For example:
$MCR NCP SET NODE 2.69 NAME BINGO
2 Assign a directory and file to receive the crash dump.
For example:
$MCR NCP SET NODE BINGO DUMP FILE\
DKA200:[ZETKIN.ANNEX_CRASH]BINGO.DMP
3 Assign the Remote Annex's hardware address to the node name.
For example:
$MCR NCP SET NODE BINGO\
HARDWARE ADDRESS 00-80-2D-00-1A-DE
4 Issue the equivalent define commands so this crash dump support
continues when your VMS load host is restored.
The VMS load host now supports crash dumps.
Customizing for Multiple Remote Annex Images
The Remote Annex operational code is installed in MOM$LOAD as
OPER_46_ENET.SYS. The Remote Annex does not require that this
be the exact file name and you may want to keep multiple versions
of the Remote Annex software.
Remote Annex 4000 Hardware Installation Guide
Chapter 2 Installing the Remote Annex 4000
2-27