Table of Contents
Advertisement
3
Push the slide mechanism to the left to secure the connection.
Figure 2-3. Connecting Thick Ethernet Cable
Connecting Twisted Pair Ethernet (10BaseT) Cable
Follow the steps in this section to connect Twisted Pair (10BaseT)
Ethernet cable to the Remote Annex 4000 (see
1
Insert the RJ-45 connector located on the Twisted Pair Ethernet cable
into the 10BaseT connector on the rear panel of the Remote Annex.
2
When the connector clicks into place, the connection is secure.
Remote Annex 4000 Hardware Installation Guide
Chapter 2
Installing the Remote Annex 4000
Figure
2-4):
2-5
Advertisement
Table of Contents
