Bay Networks Remote Annex 4000 Hardware Installation Manual page 63

The Remote Annex parameter disabled_modules disables
specified software modules and frees memory space for use by
the system.
The default Remote Annex setting for disabled_modules
includes vci which disables the Remote Annex interface for
VMS environments along with the following commands:
backwards, change, clear, crash, define, disconnect, forward,
list, logout, resume, set, and show.
Booting the Remote Annex 4000 from a VAX VMS load host
automatically enables vci. The following message appears in
the syslog file: MOP Booting, vci enabled. On subsequent boots
(regardless of the type of load host; e.g., VMS or UNIX), vci
remains enabled. To disable vci, you must re-enter it in the
disabled_modules parameter (for more details, see the Remote
Annex Administrator's Guide for UNIX).
If the disabled_modules parameter is set to vci, even if the
cli_interface parameter is set to vci, none of the VMS-specific
commands will be available, the Local > prompt will not be
displayed, and the Username> prompt will not appear upon
port reset.
Configuring NCP for Downloading
The operational image now resides in the directory to which the
logical MOM$LOAD points. You must now enable downline loading
of the image on the appropriate circuit using NCP.
Remote Annex 4000 Hardware Installation Guide
Chapter 2 Installing the Remote Annex 4000
2-25