Table of Contents
Advertisement
Chapter 2
Installing the Remote Annex 4000
Installation
2-24
Remote Annex 4000 Hardware Installation Guide
The load host has at least 4000 blocks of available disk space
(on any disk), and up to an additional 17,000 blocks available
(depending on the amount of memory installed in the
Annex) if dumps are to be supported.
In a VMS environment, dumps do not overwrite
each other, as VMS allows multiple versions of
the same file. Therefore, up to 17,000 blocks of
memory must be available for each Remote
Annex 4000 dump.
The system is backed up before installing the software.
The software medium is mounted on an appropriate device
drive, unless you are installing from save sets copied from
another load host.
Perform the following steps to install the software and image on your
system load host. To stop the installation at any time, press CTRL-Y
(^Y).
1
Log into the system manager account.
2
Enter @SYS$UPDATE:VMSINSTAL to start VMINSTAL.
VMINSTAL lists any active processes and asks if you want to
continue.
3
Enter yes and continue the installation.
4
Enter yes if you have backed up your system disk.
5
Enter the device on which your distribution medium is loaded.
*
6
Enter
for the products to be processed.
7
Press
to indicate none for installation options.
Return
8
Enter yes if you've mounted the software medium on the
appropriate device.
Advertisement
Table of Contents
