Antelope Discrete 4 Synergy Core User Manual page 10

4. Oscillator 1
Adjust the Oscillator 1 frequency.
5. Level
Choose between 0 to -18dBFS amplitude for Oscillator 1 & 2 output signal.
6. Oscillator 2
Adjust the Oscillator 2 frequency.
7. Line Out Volume
Set the Line Out volume in dB.
8. Brightness Slider
Set the Discrete 4 SC screen brightness.
9. TB Latency Mode
Lets you set the Thunderbolt™ Latency Mode to Fast, Medium, or Slow.
10. ASIO Control (Windows-only)
This is where you adjust the Discrete 4 SC ASIO driver for best performance on Windows computers.
11. Buffer Size (Samples)
Lets you set the ASIO driver buffer size. Short buffer sizes minimize latency but take more CPU power. Bigger buffer
sizes result in lighter CPU load, but generate more latency. We recommend low buffer sizes for live recording &
monitoring, and higher buffer sizes during mixdown.
12. USB Streaming Mode
Lets you switch between several latency settings for USB streaming.
3.2.2 PREAMPS
Always visible in the Control Panel, the Preamps section lets you control the Discrete 4 SC Mic Preamps. The following
options are available:
1. Gain Knobs
Turn the knobs right to increase gain, or left to attenuate.
2. Link Button
Link Preamps 1 & 2, or Preamps 3 & 4 in pairs. When switched on, adjusting the Preamp 1 gain will also change the
Preamp 2 gain, and vice versa. The same goes for Preamps 3 & 4.