Suzuki Jimny Manual page 179

NOTE:
If you pull down the "RES +/SET –" switch
(3) when the vehicle speed is less than 30
km/h or 20 mph, the maximum speed will be
set to 30 km/h or 20 mph.
Exceeding maximum speed
You can exceed the maximum speed tem-
porarily by quickly depressing the acceler-
ator pedal all the way down. While the
vehicle speed is exceeded, the speed indi-
cation (6) on the information display will
flash and the buzzer will sound briefly.
If the accelerator pedal is released to
return below the maximum speed, the
speed indication (6) will stop flashing and
then stay lit, and the function will restore.
NOTE:
• When you depress the accelerator pedal
slowly, the vehicle speed may not
exceed the maximum speed. If you wish
to exceed the maximum speed, depress
the accelerator pedal all the way down
quickly or push "CANCEL" switch (2) to
cancel the maximum speed temporarily.
• The speed indication (6) will also flash
and the buzzer will sound if the speed
limiter cannot prevent the vehicle from
exceeding the maximum speed in such
cases as when going down a steep hill,
or under excessive acceleration. In this
case, decelerate to return below the
maximum speed using the brake pedal.
Changing speed setting
Setting to the current speed
1) Push "CANCEL" switch (2).
2) Accelerate or decelerate to the desired
speed.
3) Pull down the "RES +/SET –" switch
(3), "SET" indicator (5) appear in the
information display. The current vehicle
speed is set as the maximum speed.
Using "RES +/SET –" switch
To change to a faster speed, press repeat-
edly or hold pulling up the "RES +/SET –"
switch (3).
To change to a slower speed, press
repeatedly or hold pulling down the "RES
+/SET –" switch (3).
OPERATING YOUR VEHICLE
NOTE:
• You can adjust the set speed by 1 km/h
(or 1 mph) by pulling up and down "RES
+/SET –" switch (3) quickly.
• You can adjust the set speed by 5 km/h
(or 5 mph) by pulling up and down and
holding "RES +/SET –" switch (3).
(e.g. 62 Km/h (or 42 mph) > 65 Km/h (or
45 mph) > 70 Km/h (or 50 mph), etc)
• If the current vehicle speed exceeds the
maximum speed when changing to the
slower speed using "RES +/SET –"
switch (3), the speed indication (6) will
flash and the buzzer will sound.
78RB1-01E
3-26