Suzuki Jimny Manual page 104

Hide thumbs Also See for Jimny:
Table of Contents

Advertisement

BEFORE DRIVING
Instantaneous fuel consumption
The display shows instantaneous fuel con-
sumption with a bar graph only when the
vehicle is moving.
NOTE:
• The display does not show the bar graph
unless the vehicle is moving.
• Depending on the vehicle's specification,
the fuel consumption units of initial set-
ting are indicated as L/100km, km/L or
MPG (UK).
• The indicated maximum value of instan-
taneous fuel consumption is one of the
followings. No more than the maximum
value will be indicated on the display
even if the actual instantaneous fuel
consumption is higher.
– For L/100km setting: 30
– For km/L setting: 50
– For MPG (UK) setting: 80
• The indication on the display may be
delayed if fuel consumption is greatly
affected by driving conditions.
• The display shows estimated values.
Indications may not be the same as
actual values.
2-31
Average fuel consumption
If you previously selected average fuel
consumption setting, the display shows
average fuel consumption from the last
reset to the present when the ignition
switch is turned "ON".
NOTE:
When you reconnect the terminals to the
lead-acid battery, the value of average fuel
consumption will be shown after driving for
a period of time.
You can select the timing to reset the value
of average fuel consumption by one of the
following three methods;
• Reset after refuel: the value of average
fuel consumption will be reset automati-
cally by refueling.
• Reset with trip meter A: the value of
average fuel consumption will be reset
automatically by resetting trip meter A.
• Reset manually: the value of average
fuel consumption will be reset by push-
ing and holding the indicator selector
knob (3) when the display indicates the
average fuel consumption.
To change the timing to reset the value of
average fuel consumption, refer to "Setting
mode" in this section.
NOTE:
If you add only a small amount of fuel
when you select "Reset after refuel", the
average fuel consumption value may not
be reset.
Driving range
If you selected driving range the last time
you drove the vehicle, the display indicates
"---" for a few seconds and then indicates
the current driving range when the ignition
switch is turned "ON".
The driving range shown in the display is
the approximate distance you can drive
until the fuel gauge indicates "E", based on
current driving conditions.
When the low fuel warning light comes on,
the display "---" will appear.
If the low fuel warning light comes on, fill
the fuel tank immediately regardless of the
value of driving range shown in the display.
When you refuel, the driving range is
updated. However, if you only add a small
amount of fuel, the correct value will not be
displayed.
78RB1-01E

Advertisement

Table of Contents
loading

Table of Contents