Table of Contents
Advertisement
DOK-SUPPL*-VEH*30.2***-PR03-EN-P
Rexroth IndraControl VEH 30.2 Hand-Held Terminal
9.4.2
Ethernet Adapter
Obtain an IP address via DHCP
Specify an IP address
9.4.3
Application Settings
All
information
contained
IndraControl VEH 30.2 are read from the IndraControl VAC 30.2 connection
module, see
chapter 7 "Pin Assignments of the IndraControl VEH 30.2 " on
page
63.
When commissioning the IndraControl VAC 30.2 connection mod‐
ule for the first time, all values are set to default. Standard set‐
tings are DHCP, no UDP transmission, no control, no automatic
application start.
In
the
"Ethernet
Adapter"
IndraControl VEH 30.2 is configured.
Fig.9-3:
Rexroth Settings: Ethernet Adapter
Automatic assignment of the network parameters via DHCP.
Manual configuration of the network parameters.
●
IP address: Manual input of the device's IP address.
●
Subnet Mask: Manual input of the Subnet Mask.
●
Gateway: Manual input of the Gateway.
●
DNS: Manual input of the Domain Name Server.
In the "Application Settings" tab the settings for autostart and visualization
connection to the control are configured.
Bosch Rexroth AG
in
the
"Rexroth
Settings"
tab
the
Ethernet
adapter
85/109
Software
of
the
of
the
Advertisement
Table of Contents
