Table of Contents
Advertisement
26/109
Bosch Rexroth AG
Technical Data
4.4
Enabling Device
4.5
Connection Module IndraControl VAC 30.2
Prescribed external protec‐
tion
B10d value
Tab.4-3:
Technical data, stop button
Design
Nominal voltage
Nominal current*
Prescribed external protec‐
tion
Switching cycles
Control category
B10d value
Tab.4-4:
Technical data, enabling device
Connections
Jumpering the stop pushbut‐
ton circuit with unplugged
hand-held terminal
Prescribed external protec‐
tion
Lines must be protected against short-circuits and cross-circuits by the installation!
1)
DOK-SUPPL*-VEH*30.2***-PR03-EN-P
Rexroth IndraControl VEH 30.2 Hand-Held Terminal
Fusible cut-out, 2 A time-lag
B10d: 250.000
Exclusion of failure at <6050 switching cycles
3-stage enabling device
, 2-channel, electrically iso‐
1)
lated
DC 24 V / AC 30 V protective extra low voltage
(PELV)
2 A = or 2.3 A~
Current carrying capacity of the output contacts is limi‐
ted by connected cable
Fusible cut-out, 2 A time-lag
>200000 for enabling range,
>100000 for panic position
Can be used in safety-related controls up to category
4, DIN EN 954-1 (if required with additional monitoring
modules).
Can be used in safety-related controls up to category
3 according to EN ISO 13849-1
B10d: 100.000
●
1 x Ethernet connection (RJ 45, 10/100 Base-T)
●
Stop button
●
Isolated contact "Terminal connected"
●
Enabling device
●
Voltage supply 24 V (see
ta, IndraControl VEH 30.2" on page
●
17-pin fine-thread flange to the hand-held termi‐
nal
Automatic jumpering of relay contacts
Fusible cut-out, 2 A time-lag
tab. 4-1 "Technical da‐
25)
Advertisement
Table of Contents
