Firmware Update - Solid State Logic C100 HDS Software Update Manual

C100 HDS Software Update

Firmware Update

C100 software V4.2/6 requires the following firmware to be running on the SSL PCI-E card and Madi Mezzanine cards.
T9960KF6 PCIE ROUTING & SPI 256CH
T989RPLF MADI MEZZANINE (B-RIO) CONTROL V15.0 – (for 626989X2 and 626989X3)
T989PCU9 MADI MEZZANINE CONTROL UPPER V9.0 – (for 626989X4)
• T989RPLF and T989PCU9 firmware together bring 'Loop Redundancy' functionality for consoles running V4.
Please check the version of firmware running on the SSL PCI-E card and Madi Mezzanine cards using the firm command in
tclient and, if required, update the firmware to current revision.
• The UID numbers reported by firm will be as follows for the new firmware:
T9960KF6
T989RPLF
T989PCU9
If required, please contact your SSL representative for further instruction.
Network Connection Alteration
This software update requires a slight alteration to the Ethernet configuration in redundant setups. It is now necessary to
have the master machine connected to Net 4 on the console connector panel, with the slave connected to Net 1.
For a more detailed desription of Ethernet configuration, please refer to the latest version of the C100 HDS Installation
Guide, available from www.solidstatelogic.com.
Page 2
UID :- 922
UID :- 1446
UID :- 1447