VW Golf VI, Golf Plus, Golf Variant
Coolant circuit
WARNING!
Any coolant running off should be collected in an appropriate container. Install hoses so that they are
kink-free. Unless specified otherwise, always fasten using cable ties. Position clamps so that other hos-
es cannot be damaged. The heater must be filled with coolant when installing the hoses.
The connection should be "inline" based on the following diagram:
All spring clips without a specific designation
All hose clamps
= 20-27 mm dia. All connecting pipes
2 = black (sw) protective rubber isolator
3 = black (sw) protective rubber isolator
1314421C_EN
1
2
3
A
B
= 27 mm dia. 1 = Original vehicle spring clip
= 20x20 mm dia.
(only for 1.2 and 1.4 90 kW DSG).
(for 1.4 90 kW SG only).
C
Hose in-
stallation
diagram
.
21