D8 Series User's Guide
Chapter 6: Menu and Parameter Reference
Global Setup Menu
Use the Global setup menu to set parameters that affect all loops.
Load Setup From Job
Load one of the jobs stored in battery-backed RAM. The following parameters are loaded for each
loop as part of a job:
If you have enabled remote job selection (BCD Job Load on page 100), you will see the message
below, and you will not be able to use the controller keypad to load a job.
Values: 1 to 8 (1 to 8) or none (0). Values in parentheses are for communications.
Default: none (0)
DeviceNet™ Object: Global (6B hex)
Global setup
l
Other menus
Load setup
l
from job
none
b
• PID constants, filter settings, set points and hysteresis.
• Control mode (automatic, tune, off or manual) and output power levels (if the loop is in manual
control)
• Alarm functions, set points, hysteresis and delay settings.
Load setup
l
not available
NOTE! Current settings are overwritten when you select a job from memory. Save your
current settings to another job number if you want to keep them.
r
b
r
r
99