Chapter 6:
Menu and Parameter Reference
The D8 has operator and setup parameters that let you change the configuration of the controller.
This section contains the following information for each operator and setup parameter:
• Description
• Values
• Default value
• Information for addressing controller parameters via DeviceNet™.
For information about how to access the operator and setup parameters, Chapter 4: Operation and
Setup on page 61
Operator Parameters
Use the operator parameters to change the set point, control mode or output power level.
Access the operator parameters (from the loop display).
.
Save a value and go to the next parameter.
Edit parameter values.
><
Save a value and go to the previous parameter.
,
Save a value and go to the next or previous loop.
p
Cancel a change without saving.
x
Escape to the loop display.
Figure 6.1 – Operator Parameter Navigation
Set Point
01 Set point
l
25 ˚C
b
Enter the desired value for the process variable. The new set point will take effect immediately when
you save the new value. The Set point parameter is not available if ratio control or cascade control is
enabled for the loop.
r
95