6.5
Installation
Figure 6-11
Protection guard for frame sizes FXL and GXL
A protection guard is mounted on the bottom of the Motor Module ("1" in the diagram below)
which is used when the device is being transported. The Motor Module can be placed down
on this protection guard while it is removed from the packaging and during transportation.
Before the module is installed at its final location, this guard must be removed. To do this,
remove the 4 screws ("2" in the diagram) and remove the guard.
Risk of injury due to toppling when placing down on the protection guard
A module placed down on the protection guard can topple over therefore causing injury.
• When the module is placed down on the production guard, ensure that it cannot topple
Water-cooled chassis power units for common cooling circuits
Manual, 08/2017, 6SL3097-4AM10-0BP0
Crane lifting lugs / screw coupling points for mechanical support
CAUTION
over.
Motor Modules
6.5 Installation
155