Care And Maintenance - Hilti SF 14-A Operating Instructions Manual

6.5 Drilling
1. Set the torque and operating mode selector ring to the
2. Set the forward/reverse switch to the "forward" position.
3. Switch the drill / driver on. → page 15
6.6 Hammer drilling
SFH 14-A
1. Set the selector ring to the "Hammer drilling" position
2. Switch the drill / driver on. → page 15
6.7 Switching off
▶ Release the control switch.
6.8 Removing the accessory tool
1. Set the forward/reverse switch to the middle position or remove the
battery from the power tool.
2. Open the keyless chuck.
3. Pull the accessory tool out of the keyless chuck.
7

Care and maintenance

WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance
tasks!
Care and maintenance of the tool
• Carefully remove stubborn dirt.
• Clean the air vents carefully with a dry brush.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning
agents containing silicone as these can attack the plastic parts.
Care of the Li­ion batteries
• Keep the battery free from oil and grease.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning
agents containing silicone as these may attack the plastic parts.
• Avoid ingress of moisture.
Maintenance
• Check all visible parts and controls for signs of damage at regular intervals
and make sure that they all function correctly.
• Do not operate the product if signs of damage are found or if parts
malfunction. Have it repaired immediately by Hilti Service.
16 English
Printed: 02.05.2019 | Doc-Nr: PUB / 5152170 / 000 / 03
symbol.
.