Subscribe to Our Youtube Channel
Related Manuals for Hilti SF 10W-A18
Summary of Contents for Hilti SF 10W-A18
- Page 1 SF 10W-A18 Operating instructions Mode d’emploi Manual de instrucciones Manual de instruções...
- Page 2 This Product is Certified Ce produit est homologué Producto homologado por Este produto está registrado C US...
-
Page 5: Table Of Contents
In these operating instructions, the designation “power tool” always refers to the SF 10W-A18 drill / driver with Always keep these operating instructions to- battery fitted. gether with the power tool. -
Page 6: Description
2 Description 2.1 Use of the product as directed The SF 10W-A18 is a hand-held, cordless drill / driver for driving and removing screws and for drilling in steel, wood and plastic. Do not use the battery as a power source for other unspecified appliances. -
Page 7: Technical Data
Power tool status LED 1, 2, 3, 4 Power tool overloaded or overheated 3 Technical data Right of technical changes reserved. Power tool SF 10W-A18 Rated voltage (DC voltage) 21.6 V Weight 2.7 kg (5.95 lb) Speed in 1st gear 0…310/min Speed in 2nd gear 0…530/min... - Page 8 b) Avoid body contact with earthed or grounded controlled with the switch is dangerous and must be surfaces such as pipes, radiators, ranges and repaired. refrigerators. There is an increased risk of electric c) Disconnect the plug from the power source shock if your body is earthed or grounded.
- Page 9 Use under observation, well away from flammable ma- an industrial vacuum cleaner with an officially terials, and allow it to cool down. Contact Hilti approved protection classification in compliance Service after the battery has cooled down.
-
Page 10: Before Use
(forward/reverse switch in the middle position). Use Pivot the side handle into the desired position. only the Hilti batteries approved for use with this Secure the side handle by turning the handle clock- power tool. wise. -
Page 11: Care And Maintenance
Move the forward / reverse switch to the “Forward” 6.3 Speed selection using the four-speed gear position. selector 6 NOTE 6.8 Screwdriving The mechanical four-speed gear selector can be used to select the speed range required. Please refer to the 6.8.1 Fitting the bit holder / bit illustration for the individual gear settings. -
Page 12: Troubleshooting
NOTE - If use continues, further battery discharge will be stopped automatically before the battery cells suffer damage. - Charge the batteries using the specified and approved Hilti battery chargers for Li‑ion batteries. 8 Troubleshooting Fault Possible cause Remedy The power tool doesn’t run. -
Page 13: Manufacturer's Warranty - Tools
Most of the materials from which Hilti power tools or appliances are manufactured can be recycled. The materials must be correctly separated before they can be recycled. In many countries, Hilti has already made arrangements for taking back your old power tools or appliances for recycling. Please ask your Hilti customer service department or Hilti representative for further information. - Page 14 Hilti Corporation LI-9494 Schaan Tel.: +423 / 234 21 11 Fax: +423 / 234 29 65 www.hilti.com Hilti = registered trademark of Hilti Corp., Schaan Pos. 3 | 20141112...
Need help?
Do you have a question about the SF 10W-A18 and is the answer not in the manual?
Questions and answers