Installing A Gpu Card - Dell EMC VxRail P470 Owner's Manual

Installing a GPU card

Prerequisites
1 Follow the safety guidelines listed in Safety instructions section.
2 Follow the procedure listed in the Before working inside your appliance section.
3 Remove the cooling shroud.
4 Remove the heat sinks.
Steps
1 Unpack the GPU cards and the GPU enablement kit.
2 Install the heat sinks from the kit and reinstall the cooling shroud.
3 Close the expansion card locking tab on the cooling shroud and riser.
4 Lift the expansion card latch.
5 Remove the filler brackets for the single- or double-wide GPU cards.
6 Replace the remaining filler brackets with the brackets from the GPU kit.
7 Align the GPU card connector with the slot on the riser.
8 Insert the GPU card into the riser slot until it is fully seated.
9 Locate the GPU power connectors on the cable and plug them to the six-pin and eight-pin connectors on the GPU card.
NOTE: Ensure that the GPU card is installed correctly into the GPU card lock.
10 Press down on the GPU card lock to secure the card in position.
11 Ensure that the GPU card is seated into the PCIe card holder latch.
12 Press the touch point to open the PCIe card holder latch and/or the expansion card locking tabs.
13 Connect the GPU power cable to the riser.
14 Close the expansion card latch/latches.
88 Installing and removing components