Block search
In the case of block search with calculation, the block end point (of the last sub-block) is
approached in cases where intermediate blocks have been generated as the result of the
extended functionality in SW 4.
2.1.5
Example
The example refers to the axis configuration shown in the following figure.
X, Y, Z
CM
XM
ZM
ASM
Parameter assignment
Machine axis name
● MD10000 $MN_AXCONF_MACHAX_NAME_TAB[ 0 ] = "CM" (1st machine axis: spindle/
rotary axis)
● MD10000 $MN_AXCONF_MACHAX_NAME_TAB[ 1 ] = "XM" (2nd machine axis: linear
axis)
● MD10000 $MN_AXCONF_MACHAX_NAME_TAB[ 2 ] = "ZM" (3rd machine axis: linear axis)
● MD10000 $MN_AXCONF_MACHAX_NAME_TAB[ 3 ] = "ASM" (4th machine axis: spindle)
Transformations
Function Manual, 06/2019, A5E47435470B AA
Geometry axes
1st machine axis: Rotary axis
2nd machine axis: Linear axis, perpendicular to rotary axis
3rd machine axis: Linear axis, parallel to rotary axis
4th machine axis: Main spindle
M1: Kinematics transformation
2.1 TRANSMIT face end transformation (option)
35