Installation; Unpacking; Power Wires Installation - CyberPower OLS6000E User Manual

4. Installation

The system must be installed and wired only by qualified electricians in
accordance with applicable safety regulations!
For safety, please cut off the mains power switch before installation!
When installing the electrical wiring, please note the nominal amperage of your
incoming feeder.

4.1. Unpacking

 A UPS
 A user's manual
 A USB cable
 A RS232 cable (optional)
 A parallel cable
 A parallel port cover plate
Terminal splices 12pcs (using for the wire connection on input terminal)

*PowerPanel® Business Edition software is available on our website. Please
visit www.cyberpower.com and go to the Software Section for free download.
CAUTION! Inspect the appearance of the UPS to see if there is any damage during
transportation. Do not turn on the unit and notify the carrier and dealer immediately
if there is any damage or lacking of some parts.

4.2. Power Wires Installation

4.2.1. Notes for installation:
1) The UPS must be installed in a location with good ventilation, far away from
water, inflammable gas and corrosive agents.
2) Ensure the air vents on the front and rear of the UPS are not blocked. Allow at
least 0.5m of space on each side.
3) Condensation to water drops may occur if the UPS is unpacked in a very low
temperature environment. In this case it is necessary to wait until the UPS is fully
dried inside out before proceeding installation and use. Otherwise there are
hazards of electric shock.
8