CyberPower OLS6000E User Manual page 22

The status screen
In the UPS status screen, when pressing
information about UPS information that include alarm, fault output, input, bypass,
load and battery parameter would be shown. See Fig.5-2.
when pressing
screen, when pressing
pressing
screen. The main menu includes four branches: UPS control menu, setting menu,
event menu and identification menu. See Fig.5-3.
The control menu
By pressing
control menu screen.
1) Buzzer mute
2) Battery test: is one command to control all UPS in a parallel system to do the
battery test at the same time.
3) Clear EPO status: once EPO status is enabled, the UPS output would be cut
off. To recover to normal status, first EPO connector should be closed, and
enter this menu to clear EPO status, then UPS would stop alarm and recover
to Bypass model. And UPS needs be turned on by manual operation.
4) Single UPS off: is one command to turn off one UPS which is operated
currently in parallel system, and other UPS continue working to supply the load
in the parallel system.
The setting menu
Please contact your local distributor for further information before using the settings.
Some settings would change the specification, and some settings would enable or
disable some functions. The unsuitable option set by user may result in potential
failures or protecting function loss, even directly damage the load, battery or UPS.
The most of settings could only be done while UPS is in Bypass mode.
Submenu item
User password*
Audio alarm
Site wiring fault alarm
：
> 200ms the main menu would be shown. In fault or alarm
> 200ms, the other alarm or fault would be shown by
or >200ms, and press>200ms the display would return to status
：
, enter the menu of "Control". The display would enter the next
：
enabled/disabled
enabled/disabled
enabled/disabled
or
Optional Values
19
>200ms the detailed
Default Value
disabled
enabled
enabled