System Board Assembly - Dell Inspiron 2100 Manual

Removing and Replacing Parts : Dell Inspiron 2100
3. The wire end of the speaker should face towards the center of the bottom case assembly.
4. Reinstall the two M2 x 5-mm screws to secure the speaker to the bottom case assembly.
5. Carefully connect the speaker wire to the connector in the system board assembly.
The male connector on the speaker wire is keyed to fit into the female connector one way
only.
6. Reinstall the audio EMI shield:
a. Carefully position the audio EMI shield so that the section with the two-sided tape
is over the USB connector housing.
b. Press the audio EMI shield down so it attaches to the USB connector housing.
c. Reattach the EMI adhesive sponge across the thermal cooling solution.
7. Reinstall the palm rest assembly.
8. Reinstall the keyboard assembly.
9. Reinstall the display assembly.
10. Reinstall the keyboard bezel.

System Board Assembly

file:///F|/Service%20Manuals/Dell/Inspiron/2100/remove.htm (37 of 44) [2/28/2004 6:49:34 AM]