Windows Error Messages - Dell Inspiron 2100 Manual

Solving Problems : Dell Inspiron 2100
Check the network cable connector—
firmly connected to the connector on the computer and the network wall jack.
Restart the computer—
Contact your network administrator—
correct and that the network is functioning.

Windows Error Messages

x:\ is not accessible. The device is not ready—
try again.
A filename cannot contain any of the following characters: \ / : * ? " < > |—
Do not use these characters in filenames.
Not enough memory or resources. Close some programs and try again—
have too many programs open. Close all windows and open the program that you
want to use.
The file being copied is too large for the destination drive—
are trying to copy is too large to fit on the disk, or the disk is too full. Try copying
the file to a different disk or use a larger capacity disk.
A required .DLL file was not found—
missing an essential file. To remove and then reinstall the program:
Windows Me:
1. Click the Start button, point to Settings, and then click Control Panel.
2. Double-click the Add/Remove Programs icon.
3. Select the program that you want to remove.
4. Click Add/Remove and follow the prompts on the screen.
5. See the program documentation for installation instructions.
Windows 2000:
1. Click the Start button, point to Settings, and then double-click Control
Panel.
2. Double-click the Add/Remove Programs icon.
3. Select the program that you want to remove.
file:///F|/Service%20Manuals/Dell/Inspiron/2100/solving.htm (12 of 16) [2/28/2004 6:49:25 AM]
Ensure that the network cable connector is
Try to log on to the network again.
Verify that your network settings are
The program that you are trying to open is
Insert a disk into the drive and
The file that you
You