System Components - Dell Inspiron 2100 Manual

Removing and Replacing Parts : Dell Inspiron 2100
NOTICE: The ZIF connectors are fragile. To avoid damage, do not apply too much
pressure to the movable part of the connector.
To disconnect an interface cable from a ZIF connector:
1. Insert a small flat-blade screwdriver under the movable part of the connector.
2. Pull gently upward on the movable part of the connector until it releases the interface
cable.
3. Grasp the interface cable and pull it out of the connector.
To reconnect an interface cable to a ZIF connector:
1. Use a small flat-blade screwdriver to open the movable part of the ZIF connector.
2. Orient the end of the interface cable with the ZIF connector, and insert the end of the
cable into the connector.
3. While holding the cable in place, close the ZIF connector.
To ensure a firm connection, make sure the ZIF connector is completely closed.

System Components

file:///F|/Service%20Manuals/Dell/Inspiron/2100/remove.htm (6 of 44) [2/28/2004 6:49:34 AM]